Youngjae Kim

By Youngjae Kim, Youngjo Kang and Kazuki Morita

In spite of practical importance in the pyro-metallurgy process, thermal conductivity of molten oxide system has not been sufficiently studied due to its notorious convection and radiation effects. By an aid of appropriate modification of measurement technique and evaluations for systematic errors, thermal conductivity measurement at high temperature becomes feasible. In this chapter, thermal conductivity measurement technique for high-temperature molten oxide system was discussed along with related experimental errors. In addition, thermal conduction mechanism by phonon was briefly introduced. The laser flash method and hot-wire method, which are representative measurement methods for high-temperature system, were compared. During the measurement by using hot-wire method, the convection and radiation effects on measurement results were evaluated. In the hot-wire method, both convection and radiation effects were found to be negligible within short measurement time. Finally, the effect of network structure of molten oxide system on thermal conductivity was discussed. The positive relationship between thermal conductivity and polymerization in the silicate and/or borate system was presented. In addition, the effect of cation expressed by function of ionization potential on thermal conductivity was also briefly introduced. This chapter is partially based on a dissertation submitted by Youngjae Kim in partial fulfillment of the requirements for the degree of Doctor of Philosophy at The University of Tokyo, September 2015.

Part of the book: Impact of Thermal Conductivity on Energy Technologies