Chapters authored
Construction Technology of Precast Pier Foundation Filled with Demolished Concrete Lumps
Applying of demolished concrete lumps (DCLs) in the pier foundation is an effective way to improve the efficiency of construction waste resource utilization. Fifty-two cylindrical specimens with the size of ∅ 250 mm × 500 mm were fabricated by mixing of DCLs with the fresh concrete (FC) and used to investigate the influence of two key factors, the gradation of the DCLs and the height setting of layered “steel mesh,” on the uniaxial compression and flexural strength properties of the compound concrete specimens. Results indicate that the layered “steel mesh” in the specimens can restrain the settlement and segregation of the DCLs and improve the compressive and flexural strength of the specimens significantly. Normally, there are two types of failure damage mode of the test pieces, the failure of the interface between DCLs and the FC and the fracture failure of the DCLs. When the stress level is below 0.5, the test piece is in the elastic stage. Crack development occurs when stress level further increase to 0.7–0.9. The pieces with the layered pouring height of H2 and the DCLs of R3 present the optimum compressive strength and flexural strength and also best construction effect.
Part of the book: Advances and Technologies in Building Construction and Structural Analysis
Vertical Bearing Capacity of Precast Pier Foundation Filled with Demolished Concrete Lumps
The application of recycled compound concrete made of demolished concrete lumps (DCLs) and fresh normal concrete in pier foundation can effectively improve the utilization efficiency of construction waste resources. In this study, two prefabricated pier foundations based on recycled compound concrete (dimension of Ø800 × 2500 mm and Ø1000 × 2500 mm) and two cast-in-place pier foundations based on ordinary concrete (dimension of Ø800 × 2500 mm and Ø1000 × 2500 mm) were tested. Special attention was devoted to the load-settlement curve characteristics of the precast pier foundation of compound concrete, the load transfer law of the pier-soil system, the soil pressure distribution at the bottom of the pier, and the failure mode. The results showed that the Q-S curve of precast concrete pier foundation made of recycled compound concrete is slow deformation at loading, which is consistent with that of cast-in-place concrete pier foundation. The load transfer theory of pier-soil system is established, and its accuracy is verified by experimental analysis. The precast foundation of recycled compound concrete is the same as the cast-in-place foundation of ordinary concrete. The failure form of prefabricated pier foundation made of recycled compound concrete was a local shear failure, while the failure form of ordinary concrete cast-in-place pier foundation was piercing-type shear failure. The feasibility of relevant theoretical methods for calculating the vertical ultimate bearing capacity is examined.
Part of the book: Advances and Technologies in Building Construction and Structural Analysis