Sung-Hua Wu

By Sung-Hua Wu

The study proposed an important micro-specific coefficient based on the mathematical modeling of micro-cutting resistance to predict the mechanic conditions at cutter-edge radius. For the steady-state chip formation in the micro-cutting process, the differential angle is usually constant, and the plowing angle and rake angle are relative to the tool-edge radius, cutting resultant force, plowing resistance, surface roughness, and shearing resistance on the tool-workpiece. The optimal process included a cut of depth of 0.001 mm, cutting length of 0.003 mm, cutter-edge temperature of 38°C, and an edge radius of 0.0005 mm on workpiece Al-7075; the optimal cutting force in x-axis was 0.0005 N (Avg.) and the optimal cutting force in y-axis was 0.00028 N (Avg.) for better surface roughness Ra = 0.16. The higher temperature was 42.16°C on the workpiece and tool HSS, and the maximum strain rate occurred on the chip shearing zone was 9.33E6 (/s), which obeyed the generalized cutting criterion by numerical analysis. While the micro-specific coefficient is close to 1, the plowing zone will increase friction, stress, resistance, and even cutting excited vibration, resulting in discontinuous chipping. Besides, the process developed the micro-MDOF cutting dynamics model and applied a fractal equation to simulate the micro-cutting process. The validation can be proved as the derived theory agreed well with the simulation in the micro-cutting process.

Part of the book: Micromachining