Chapters authored
Perspective of Additive Manufacturing Selective Laser Melting in Co-Cr-Mo Alloy in the Consolidation of Dental Prosthesis
This chapter seeks to compare the properties of samples manufactured by additive manufacturing (AM) by the selective laser melting (SLM) technology and compare with the precision casting (PC) processes using the Co-Cr-Mo (ASTM F75) alloy to manufacture of dental prosthesis. This AM process can be manufactured three-dimensional models by means of a laser beam that completely melts particles of powder deposited layer by layer. However, it is still relevant to know the properties of: performance, dimensional, mechanical and microstructural of this laser melting process and compare with a convencional process. The results of mechanical evaluation showed that the SLM technique provides superior mechanical properties compared to those obtained by the PC technique. It is possible to verify that the consolidation by SLM technique results in lower presence of porosity than PC technique. In addition, PC samples presented a gross dendritic microstructure of casting process. Microstructural analysis of SLM samples results in a characteristic morphology of layer manufacturing with ultrafine grains and a high chemical homogeneity. In this way, the development of the present study evidenced to improve the manufacture of customized components (copings) using the SLM technology.
Part of the book: Biomaterials in Regenerative Medicine