We discuss the charging behavior of clays and clay minerals in aqueous electrolyte solutions. Clay platelets exhibit different charging mechanisms on the various surfaces they expose to the solution. Thus, the basal planes have a permanent charge that is typically considered to be independent of pH, whereas the edge surfaces exhibit the amphoteric behavior and pH-dependent charge that is typical of oxide minerals. Background electrolyte concentration and composition may affect these two different mechanisms of charging in different ways. To guide and to make use of these unique properties in technical application, it is necessary to understand the effects of the various master variables (i.e. pH and background salt composition and concentration). However, how to disentangle the various contributions to the charge that is macroscopically measurable via conventional approaches (i.e. electrokinetics, potentiometric titrations, etc.) remains a challenge. The problem is depicted by discussing in detail the literature data on kaolinite obtained with crystal face specificity. Some results from similar experiments on related substrates are also discussed. As an illustration of the complexity, we have carried out extensive potentiometric mass and electrolyte titrations on artificial clay samples (Na-, Ca-, and Mg-montmorillonite). A wide variety of salts was used, and it was found that the different electrolytes had different effects on the end point of mass titrations. In the case of a purified sample (i.e. no acid-base impurities), the end point of a mass titration (the plateau of pH achieved for the highest concentrations of solid), in principle, corresponds to the point of zero net proton and hydroxide consumption, at which in ideal systems, such as oxide minerals, the net proton surface charge density is zero. To such concentrated (dense) suspensions of clay particles, aliquots of salts can be added and the resulting pH indicates the specificity of a given salt for a given clay particle system. In the experimental data, some ambiguity remains, which calls for further detailed and comprehensive studies involving the application of all the available techniques to one system. Although, right now, the overall picture appears to be clear from a generic point of view (i.e. concerning the trends), clearly, in a quantitative sense, huge differences occur for nominally identical systems and only such a comprehensive study will allow to proof the current phenomenological picture and allow the next step to be taken to understand the fine details of the complex clay-electrolyte solution interfaces.
Part of the book: Clays, Clay Minerals and Ceramic Materials Based on Clay Minerals
Although previous studies have shown that sulfate can either increase cation leaching or enhance cation adsorption in soil, little is known about the factors behind these phenomena. To learn more about them, calcium adsorption experiments were carried out with kaolinite and gibbsite at initial pH values 4 and 6 and in the presence of 1 or 20 mmolc L−1 of either nitrate or sulfate. The results indicated that limited sulfate-calcium coadsorption occurred on gibbsite when it was in contact with the dilute solution of CaSO4.2H2O at pH ~ 7. Regarding mineral and pH values, calcium adsorption from the concentrated solutions decreased with sulfate possibly because of the presence of ~31% of the CaSO40 ion pair in the concentrated CaSO4.2H2O solutions and the low free calcium activity therein. Calcium adsorption on kaolinite and gibbsite from all concentrated solutions was reduced when the initial pH changed from 4 to 6 suggesting a negative salt effect on that process. In addition to indicating negligible participation of gibbsite in calcium adsorption, our findings also suggest that higher amounts of gypsum applied to lime-amended oxisols reduce the effectiveness of the main oxisol clay-sized mineral capable of adsorbing cations, i.e., kaolinite, to impair calcium leaching. The uptake data were complemented with some zeta-potential measurements, which supported the lack of substantial uptake of calcium even in the presence of sulfate. Some modeling calculations using the only available model covering sulfate and calcium on gibbsite have been done to rationalize the experimental data, but the model is only able to involve pure electrostatic attraction of calcium, which is not sufficient to produce substantial uptake. Finally, the aluminol basal plane that is present on both gibbsite and kaolinite has been additionally studied using second harmonic generation (SHG) down to 4°C, because the ion-pair formation decreases with decreasing temperature. The second harmonic results confirm the patterns observed in the electrokinetic measurements with kaolinite being quite comparable to the sapphire basal plane. Also and quite clearly, the presence of CaSO4 solutions caused temperature dependence different from pure CaCl2 and Na2SO4 solutions. The latter were essentially behaving like pure water. The difference between the calcium chloride and sulfate systems can be explained by sulfate interaction and might be linked to the temperature dependence of the formation of the CaSO4 ion pair. The temperature dependency study could be an important starting point for looking at ice nucleation in the presence of the three different solutions and more strongly link aqueous chemistry to ice nucleation processes.
Part of the book: Advanced Sorption Process Applications