Chapters authored
Pulsed Laser-Deposited TiO2-based Films: Synthesis, Electronic Structure and Photocatalytic Activity
Active under visible light, photocatalysts based on doped titania were obtained via pulsed laser deposition (PLD) method. To find out the crystalline structure, optical properties, and electronic structure, the following techniques such as X-ray diffraction, electronic spectroscopy, electrical conductivity measurements, and X-ray photoelectron spectroscopy (XPS) are used. Photocatalytic activity is monitored by applying the photoreduction of dichromate ions under UV and visible light. The influence of zirconium ions and its content and synthesis conditions on the efficiency of nitrogen incorporation into titania structure that, in turn, determines the electronic structure and photocatalytic ability of the semiconductive materials are discussed. A substitutional nitrogen (Ti–N) rather than an interstitial one (Ti–O–N) is mainly responsible for the observed photoactivity. It is pointed that substitutional nitrogen is responsible for bandgap narrowing or formation of intragap localized states within semiconductor bandgap. The bandgap energy values are sharply decreased, while the relative intensity of substitutional nitrogen XPS peaks is increased. Pulsed laser synthesis of TiO2 films in N2/CH4 atmosphere not only leads to nitrogen incorporation but also to the formation of defects including oxygen vacancies and Ti3+ states which are all contributing to light absorption. An appropriate ratio of gas mixture, optimum zirconia content, suitable pressure, and temperature during synthesis was found for the synthesis of highly active semiconductive films. The highest photocatalytic conversion yields are obtained for nitrogen-doped 10% ZrO2/TiO2 synthesized in N2:CH4 = 5:1 at 100 Pa and at 450°C under both UV and visible light.
Part of the book: Semiconductor Photocatalysis